3D printed racing drone, part 3

It is done. It is alive. My 3D printed FPV racing drone works. A few weeks ago I finally flight tested my design and it works! Even better than expected, since I survived the experience without a scratch. OK, I did not crash it yet, but give me some time for that too….

3d printed fpv racing drone

And I have a cool name for it: Isando which means hammer in Zulu. Kind of fits, right?

Ah, STL files are available on Thingiverse of course.

3D printed racing drone, part 2

My 3D printed racing drone is done. More or less. I was able to finish it a few weeks ago and even perform a maiden flight. It survived the experience, but I also discovered few problems I will have to solve before officially calling this project a success.

3D Printed Racing FPV Drone

3D Printed Racing FPV Drone

First of all, the decision about hard mounting a flight controller and not installing a capacitor on mains was a bad one. Not only motors are "twitching" from time to time, a video is very noisy. I hope big low ESR capacitor will solve that, since there is no way for soft mounting for this frame.

3D Printed Racing FPV Drone

Besides that, it worked just fine. I will try to prepare a video from the maiden flight in a few day, for now only a few pictures and final specification:

  • Frame: PLA 3D Printed, 220mm motor-to-motor diagonal
  • Motors: EMAX RS2205S 2300KV
  • ESC: Racestar RS30A BLHeli_S
  • Flight controller: FrSky XSRF3O running Betaflight 3.2
  • VTX: TS5823 200mW
  • Camera: RunCam Swift
  • Total weight, no battery: 380g

Total build is, of course, heavy, but not that heavy as I feared. I was expecting something way above 400g. The frame is also quite stiff. I wonder how much beating it will be able to take….

3D Printed Racing FPV Drone

3D printed racing drone, part 1

I've been pretty busy last 2 weeks. Among other things, I've started to design 3D printed racing drone frame. I'm fully aware there are plenty designs available on Thingiverse, but almost all of them forgets that plastic filament is not carbon fiber laminate and what works well with carbon, will fail with filament. So, I came up with this:

3D Printed Racing Drone

3D Printed Racing Drone

  • suitable to 220x and 230x motors with 19x16mm hole spacing
  • fits PCB and 36x36mm flight controller (30.5mm hole spacing)
  • size: 220mm motor to motor (diagonal)
  • fits "standard size" FPV camera

It is heavy for sure. It has thick arms and a lot of M3 nuts and bolts connecting all the parts together. I hope it will be enough to survive at least some beating… First flight in a few weeks since I'm still waiting for motors.